Powered by GoogleTranslate
Standard Interpretations - Table of Contents
• Standard Number: 1910.1200(f)(1); 1910.1200(f)(1)(vi)

March 22, 2013

Mr. Dennis Morikawa
Morgan, Lewis & Bockius LLC
1701 Market Street
Philadelphia, PA 19103-2921

Dear Mr. Morikawa:

Thank you for your March 4, 2013, email to the Occupational Safety and Health Administration (OSHA) Directorate of Enforcement Programs. We apologize for the delay in responding to your earlier inquiry. Your questions concern specific sections of the labeling requirements under the revised Hazard Communication standard (HCS 2012), 29 CFR 1910.1200. This letter constitutes OSHA's interpretation only of the requirements herein, and may not be applicable to any questions not delineated within your original correspondence. Your paraphrased questions and our responses are below.

Question 1: Can the web address for the company be used instead of a physical or mailing address on the required HCS 2012 label?

Response: No. While the web address for your company may provide contact information, many small businesses do not have ready access to the internet. Therefore, the address required by 29 CFR 1910.1200(f)(1)(vi) is the physical or mailing address for the manufacturer, importer or distributor. The web address for your company may be included on the label as supplemental information. It may serve as an additional manner to request and transmit information for those businesses that have internet access, but it cannot replace the physical or mailing address. Please see the August 31, 2009, letter to Ms. Peggy Haase concerning mailing addresses versus physical addresses, http://www.osha.gov/pls/oshaweb/owadisp.show_document?p_table=INTERPRETATIONS&p_id=27206.

Question 2: Must the legal name of the company (e.g., Airgas USA, LLC) be used on the HCS 2012 label or can the trade name (e.g., Airgas) be used instead?

Response: OSHA's requirement at [29 CFR 1910.1200(f)(1)(vi)] to include the name of the manufacturer, importer or distributor on the label and safety data sheet serves to ensure that downstream users know whom to contact if they have any questions. If the trade name of the company is recognizable to downstream users, then that name can be used on the label and safety data sheet (SDS). OSHA expects that the same company name (e.g., Airgas) would be used on the label and SDS. If it is difficult to associate the trade name on the label and the full legal company name on the SDS, it may potentially create confusion. This would not be compliant.

Thank you for your interest in occupational safety and health. We hope you find this information helpful. OSHA's requirements are set by statute, standards, and regulations. Our letters of interpretation do not create new or additional requirements, but rather explain these requirements and how they apply to particular circumstances. This letter constitutes OSHA's interpretation of the requirements discussed. From time to time, letters are affected when the Agency updates a standard, a legal decision impacts a standard, or changes in technology affect the interpretation. To ensure that you are using the correct information and guidance, please consult OSHA's website at http://www.osha.gov. If you have further questions, please feel free to contact the Office of Health Enforcement at (202) 693-2190.

Sincerely,




Thomas Galassi, Director
Directorate of Enforcement Programs

Enclosure

[Corrected on 7/14/2014]


Standard Interpretations - Table of Contents

Thank You for Visiting Our Website

You are exiting the Department of Labor's Web server.

The Department of Labor does not endorse, takes no responsibility for, and exercises no control over the linked organization or its views, or contents, nor does it vouch for the accuracy or accessibility of the information contained on the destination server. The Department of Labor also cannot authorize the use of copyrighted materials contained in linked Web sites. Users must request such authorization from the sponsor of the linked Web site. Thank you for visiting our site. Please click the button below to continue.

Close