US Dept of Labor

Occupational Safety & Health AdministrationWe Can Help

Standard Interpretations - Table of Contents
• Standard Number: 1928.51

October 22, 1981

Mr. William E. Lawler
Specifications Manager
Indian Mills & Manufacturing, Inc.
120 West Main Street
Carmel, Indiana 46032

Dear Mr. Lawler:

Thank you for your letter of October 5, 1981, requesting a clarification of 29 CFR 1928.51, Roll-over Protective Structures (ROPS) for tractors used in agricultural operations.

It was not the intent of 29 CFR 1928.51(b)(2)(ii)(B) to make the seat belt load requirement equal to the seat belt anchorage load requirement as mentioned in your letter. 29 CFR 1928.51(b)(2)(ii) requires each seat belt to meet the requirements set forth in Society of Automotive Engineers Standard SAE J4C, 1965 Motor Vehicle Seat Belt Assemblies, except as noted in Subparagraphs A, B and C.

If I may be of further assistance, please feel free to call or write.

Sincerely,



Bruce Hillenbrand
Deputy Director,
Federal Compliance and State Programs


Standard Interpretations - Table of Contents

Thank You for Visiting Our Website

You are exiting the Department of Labor's Web server.

The Department of Labor does not endorse, takes no responsibility for, and exercises no control over the linked organization or its views, or contents, nor does it vouch for the accuracy or accessibility of the information contained on the destination server. The Department of Labor also cannot authorize the use of copyrighted materials contained in linked Web sites. Users must request such authorization from the sponsor of the linked Web site. Thank you for visiting our site. Please click the button below to continue.

Close