Powered by GoogleTranslate
Standard Interpretations - Table of Contents
• Standard Number: 1926.302(e)(5); 1926.302(e)(6)

September 2, 1975

Subject: Request for Interpretation - 1926.302(e), Powder Operated Handtools

This is in response to your memorandum of June 23, 1975, with attached material from Hilti, Inc., regarding an interpretation of 1926.302(e)(5) and (6). In addition, this confirms Jeff Campbell's phone call of July 18, 1975.

In developing and promulgating 29 CFR 1926.302(e) Powder-actuated tools, the magazine or clip-fed explosive power load was not considered. This is a magazine containing several explosive power loads which is inserted into the tool and single loads are fed into the ram (firing chamber) as needed.

Our information indicates that, in addition, the following standards did not address magazine-fed explosive power loads:

ANSI A10.3-1970 safety requirements for explosive-actuated fastening tools.

29 CFR 1910.243(d) Explosive actuated fastening tools

29 CFR 1915.75 Powder actuated fastening tools

29 CFR 1916.75 Powder actuated fastening tools

When magazine-fed tools are inspected, the tool is not considered loaded until the magazine feeds the tool.

An OSHA Program Directive #100 series will be issued to cover this subject.

Barry J. White
Associate Assistant
Secretary for Regional Programs

Standard Interpretations - Table of Contents

Thank You for Visiting Our Website

You are exiting the Department of Labor's Web server.

The Department of Labor does not endorse, takes no responsibility for, and exercises no control over the linked organization or its views, or contents, nor does it vouch for the accuracy or accessibility of the information contained on the destination server. The Department of Labor also cannot authorize the use of copyrighted materials contained in linked Web sites. Users must request such authorization from the sponsor of the linked Web site. Thank you for visiting our site. Please click the button below to continue.