Powered by GoogleTranslate

Occupational Safety and Health Administration OSHA

Inspection Detail

Case Status: OPEN

Note: The following inspection has not been indicated as closed. Please be aware that the information shown may change, e.g. violations may be added or deleted. For open cases, in which a citation has been issued, the citation information may not be available for 5 days following receipt by the employer for Federal inspections or for 30 days following receipt by the employer for State inspections.

Inspection: 1403360.015 - R & A Roof Structures, Inc.

Inspection Information - Office: Ca San Bernardino

Nr: 1403360.015Report ID: 0950633Open Date: 05/24/2019

R & A Roof Structures, Inc.
24975 Nandina Ave.Null
Moreno Valley, CA 92555
Union Status: NonUnion
SIC:
NAICS: 238130/Framing Contractors
Mailing: 18533 Collier Avenue, Suite Anull, Lake Elsinore, CA 92530

Inspection Type:Fat/Cat
Scope:Partial Advanced Notice:N
Ownership:Private
Safety/Health:Safety Close Conference:08/22/2019
Close Case:

Related Activity:TypeIDSafetyHealth
 Accident1458657    
Case Status: OPEN

Violation Summary
Serious Willful Repeat Other Unclass Total
Initial Violations 2 2
Current Violations 2 2
Initial Penalty $29,700 $0 $0 $0 $0 $29,700
Current Penalty $29,700 $0 $0 $0 $0 $29,700
FTA Amount $0 $0 $0 $0 $0 $0

Violation Items
# ID Type Standard Issuance Abate Curr$ Init$ Fta$ Contest LastEvent
  1. 01001 Serious 1593(L) 08/22/2019 09/18/2019 $11,700 $11,700 $0 09/27/2019 C - Contested
  2. 02001 Serious 17160001 C01 08/22/2019 $18,000 $18,000 $0 09/27/2019 C - Contested

Accident Investigation Summary
Summary Nr: 116532.015Event: 05/24/2019Employee Welding Roof Panel Is Killed In Fall
At 6:30 a.m. on May 24, 2019, Employee #1 and a coworker who was his supervisor, both employed by a roofing company, were installing a panelized roofing system for a new concrete tilt up commercial building. Employee #1 was positioned on t he section of panelized roof being installed and using a portable welding unit t o secure the panel structure to the building. His coworker was operating a roug h terrain forklift that was lifting roof panels into place. The forklift struck the panel structure, causing it to vibrate and fall. Employee #1 fell, a fall height of 43 feet, and struck the concrete floor. He was killed in the fall. T he subsequent investigation determined that Employee #1 had been wearing a fall protection harness and lanyard, but the lanyard had not been attached to an anch or point on the roof system.
Keywords: aerial lift, anchor, construction, equipment operator, fall, fall protection, installing, lanyard, roof, roof panel, roofer, struck by, tie-off, welding
Inspection Degree Nature Occupation
1 1403360.015 Fatality Welders and cutters

Thank You for Visiting Our Website

You are exiting the Department of Labor's Web server.

The Department of Labor does not endorse, takes no responsibility for, and exercises no control over the linked organization or its views, or contents, nor does it vouch for the accuracy or accessibility of the information contained on the destination server. The Department of Labor also cannot authorize the use of copyrighted materials contained in linked Web sites. Users must request such authorization from the sponsor of the linked Web site. Thank you for visiting our site. Please click the button below to continue.

Close