Powered by GoogleTranslate

Occupational Safety and Health Administration OSHA

Inspection Detail

Case Status: VIOLATIONS UNDER CONTEST

Note: The following inspection has not been indicated as closed. Please be aware that the information shown may change, e.g. violations may be added or deleted. For open cases, in which a citation has been issued, the citation information may not be available for 5 days following receipt by the employer for Federal inspections or for 30 days following receipt by the employer for State inspections.

Inspection: 1094344.015 - William A. Hazel, Inc.

Inspection Information - Office: Virginia Safety 4

Nr: 1094344.015Report ID: 0355114Open Date: 09/24/2015

William A. Hazel, Inc.
6161 Willow Place
Bealeton, VA 22712
Union Status: NonUnion
SIC:
NAICS: 238910/Site Preparation Contractors
Mailing: 4305 Hazel Park Court, Chantilly, VA 20151

Inspection Type:Fat/Cat
Scope:Partial Advanced Notice:N
Ownership:Private
Safety/Health:Safety Close Conference:09/24/2015
Emphasis: S:Fri, N:TrenchClose Case:

Related Activity:TypeIDSafetyHealth
 Accident1023114    
Case Status: VIOLATIONS UNDER CONTEST

Violation Summary
Serious Willful Repeat Other Unclass Total
Initial Violations 2 2
Current Violations 2 2
Initial Penalty $0 $126,000 $0 $0 $0 $126,000
Current Penalty $0 $126,000 $0 $0 $0 $126,000
FTA Amount $0 $0 $0 $0 $0 $0

Violation Items
# ID Type Standard Issuance Abate Curr$ Init$ Fta$ Contest LastEvent
  1. 01001 Willful 19260651 K02 03/21/2016 03/25/2016 $63,000 $63,000 $0 04/01/2016 -
  2. 01002 Willful 19260652 A01 03/21/2016 03/25/2016 $63,000 $63,000 $0 04/01/2016 -

Accident Investigation Summary
Summary Nr: 79808.015Event: 09/24/2015Employee Is Killed When Pipe Saw Kicks Back And Strikes Empl
At approximately 11:53 a.m. on September 24, 2015, a crew was working in a trench approximately 11 feet in depth. Water pipes were being replaced for upgrades. An employee was using a Hilti Cut-Off Saw, Model Number DSH 900, known as a pipe saw, to cut an 8-inch in diameter, 3-feet in length duct tile iron pipe. The saw blade was guarded. The crew was making a Tee section into the pipe to install a new fire hydrant. It appears the pipe was cut through on the top side but not on the bottom. The employee was observed cutting and seconds later observed holding his throat. The actual event was not witnessed. When the saw was removed from the trench, a rock was stuck to the blade. It was evident that the saw hung up and kicked back striking the employee in the neck. The employee was killed at the scene.
Keywords: trench, kick back, neck, saw, struck by
Inspection Degree Nature Occupation
1 1094344.015 Fatality Cut/Laceration

Thank You for Visiting Our Website

You are exiting the Department of Labor's Web server.

The Department of Labor does not endorse, takes no responsibility for, and exercises no control over the linked organization or its views, or contents, nor does it vouch for the accuracy or accessibility of the information contained on the destination server. The Department of Labor also cannot authorize the use of copyrighted materials contained in linked Web sites. Users must request such authorization from the sponsor of the linked Web site. Thank you for visiting our site. Please click the button below to continue.

Close