Violation Detail
Standard Cited: 5A0001 OSH Act General Duty Paragraph
Inspection Nr: 307999102
Citation: 01001
Citation Type: Serious
Abatement Date: 02/14/2005 X
Initial Penalty: $4,900.00
Current Penalty: $4,165.00
Issuance Date: 02/08/2005
Nr Instances: 1
Nr Exposed: 2
Related Event Code (REC): A
Gravity: 10
Report ID: 0420600
Contest Date: 03/01/2005
Final Order: 07/01/2005
Emphasis:
| Type | Latest Event | Event Date | Penalty | Abatement Due Date | Citation Type | Failure to Abate Inspection |
|---|---|---|---|---|---|---|
| Penalty | F: Formal Settlement | 07/01/2005 | $4,165.00 | 02/14/2005 | Serious | |
| Penalty | Z: Issued | 02/08/2005 | $4,900.00 | 02/14/2005 | Serious |
Text For Citation: 01 Item/Group: 001 Hazard: CONFINED
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard of dangerous concentrations of toxic substances and/or a fire/explosion hazard during confined space entry: Location: 2450 Old Combee Rd. Lakeland, FL at the Northeast Water Treatment Plant a) On or about August 10, 2004, employees entered a water filter tank to spray paint the interior surfaces with a flammable paint. The employer did not implement a Confined Space Program. Among other methods, one feasible and acceptable abatement method to correct this hazard is to establish and implement a confined space program such as that specified in ANSI Z117.1-1995. Such a program shall include, as a minimum, the following elements: 1.Develop and utilize effective procedures for confined space entry, including, but not limited to, using a permit system, ventilation, atmospheric testing, rescue procedures, employee training, designation of qualified people for standby and emergency procedures. 2.The completion and posting of a confined space entry permit which requires authorization and approval in writing that specified that all existing hazards have been evaluated by a qualified person and the necessary protective measures have been taken to ensure the safety of each worker. 3.Blinding, blocking, bleeding, purging, lockout or any other steps necessary to reduce to and ensure zero mechanical and thermal state all mechanical, electrical, hydraulic, pneumatic, liquid and gas systems relating to the confined space should any of these systems be put in motion or otherwise activated. 4.Mechanical ventilation of the confined space prior to entry and continued ventilation to provide a safe atmosphere, when determined necessary as described in (2) above. 5.Testing the atmosphere of the confined space prior to entry and on a regular basis for the presence of sufficient oxygen and absence of hazardous levels of toxic or combustible gases or vapors, when determined necessary as described in (2) above. 6.Emergency rescue procedures with requirement that trained personnel are available and are stationed outside the confined space with proper equipment to provide for the rescue of personnel entering the space as determined necessary as described in (2) above. Such equipment must include safety harness and life lines with provisions for hoisting employees from the confined space. If entry is required for rescue, the rescuing employee must be equipped with approved air supplied respiratory protection and other appropriate personal protective equipment. 7.Training of any and all employees required to enter the confined space and all employees required to standby for rescue. This training shall include procedures required prior to entry, during occupation of the confined space, procedures for safe rescue of employees in the confined space and the hazards associated with work in confined spaces.d
Translate