Archive Notice - OSHA Archive

NOTICE: This is an OSHA Archive Document, and may no longer represent OSHA Policy. It is presented here as historical content, for research and review purposes only.

Department of Labor Logo
OSHA Trade Release

Please note: As of January 20, 2021, information in some news releases may be out of date or not reflect current policies.

Trade News Release
January 18, 2006
Contact: Frank Meilinger
Phone: (202) 693-1999

OSHA Revokes Slip Resistance Provision from Steel Erection Standard

WASHINGTON -- The Occupational Safety and Health Administration (OSHA) today announced it is revoking a provision of the steel erection standard that addresses the slip resistance of walking surfaces of coated structural steel members.

The provision requires that coated structural steel meet a specified level of slip resistance when measured using ASTM test methods. The technical developments that needed to occur for employers to comply with the provision by its effective date, July 18, 2006, have not occurred. The ability to comply with the slip resistance provision depends upon two technical developments: (1) completed industry protocols for slip testing equipment, and (2) the availability of suitable slip resistant coatings.

Rulemaking comments indicated that the test methods are not likely to be completed by the July effective date because ASTM will not have completed the required validation process. Comments also indicated that ASTM will likely withdraw the test methods altogether because they are brand-specific rather than generic. Lack of completed test methods has delayed the development of suitable slip resistant coatings. In addition, there has not been adequate testing of coatings to determine whether they have sufficient durability in the variety of applications in which they will be used, especially in corrosive environments.

In 2004, OSHA conducted a limited reopening of the rulemaking record, as part of a settlement to resolve legal challenges to the slip resistance provision. The Agency asked for comments on whether suitable and appropriate test methods, and slip-resistant coatings could reasonably be expected to be available by July 2006. In the settlement agreement, the Agency also committed to publishing a notice by January 18, 2006, reaffirming, amending, or revoking the provision.

The steel erection standard is the first OSHA safety standard developed under the Negotiated Rulemaking Act of 1990 and the Department's Negotiated Rulemaking Policy. The standard addresses the hazards that have been identified as the major causes of injuries and fatalities in the steel erection industry. The slip resistance provision was not intended to be the sole or primary means of protecting workers from fall hazards. Rather, it was intended to complement other requirements in the steel erection standard as part of a collective strategy for reducing these fall-related injuries and fatalities.

Notice of the revocation of the slip resistance provision appears in today's Federal Register.

Employers are responsible for providing a safe and healthful workplace for their employees. OSHA's role is to assure the safety and health of America's workers by setting and enforcing standards; providing training, outreach, and education; establishing partnerships; and encouraging continual process improvement in workplace safety and health. For more information, visit

# # #

U.S. Labor Department news releases are accessible on the Internet at The information in this release will be made available in alternative format upon request (large print, Braille, audio tape or disc) from the COAST office. Please specify which news release when placing your request. Call 202-693-7773 or TTY 202-693-7755.