Newsletter
RSS Feeds
Print This Page
Text Size
Standard Number > 1910 > 1910.179
- 1910.179 - A crane may be used for rated load testing of below-the-hook lifting device provided the test does not exceed 125% for the crane's rated load. [08/08/1994]
- 1910.179 - A worm drive gearbox is not considered to be a holding brake. [11/15/2005]
- 1910.179 - Acceptable use of load-limiting clutches as upper and/or lower limit devices. [01/11/2001]
- 1910.179 - Application of bridge brakes. [10/08/1991]
- 1910.179 - Clarification of OSHA standard on Overhead and Gantry Cranes [03/04/1991]
- 1910.179 - Clarification of Overhead and Gantry Cranes definition of "complete inspection" and "periodic inspection" requirements. [08/28/2003]
- 1910.179 - Clarification of overhead and gantry cranes. [01/03/1997]
- 1910.179 - Clarification on whether a visual rotating beacon or strobe light is an acceptable warning signal on a radio operated crane. [03/30/2010]
- 1910.179 - Comments on Variance Application Number 2293. [09/18/1995]
- 1910.179 - Compliance for crane hoisted personnel platforms. [07/22/1996]
- 1910.179 - Definition of "extreme low position" for overhead and gantry cranes. [11/03/2005]
- 1910.179 - Hoists that have two upper "hoist limit switches". [11/29/1993]
- 1910.179 - Holding brake requirements on overhead cranes. [11/08/1996]
- 1910.179 - Inspection certification record requirements in overhead and gantry cranes. [10/21/1997]
- 1910.179 - Inspection of Crane Hooks. [02/12/1992]
- 1910.179 - Inspection of running ropes. [03/27/1992]
- 1910.179 - Interpretation of 1910.179, Overhead and Gantry Cranes [04/23/1984]
- 1910.179 - Interpretation of the overhead and gantry cranes standard. [09/26/1996]
- 1910.179 - Loads must be attached to the block hook by a sling or other approved device and may not be attached directly to the running rope. [10/06/2004]
- 1910.179 - OSHA's position that the main or emergency switches must be capable of being locked out. [07/01/1982]
- 1910.179 - Overhead and Gantry Cranes. [01/04/1977]
- 1910.179 - Requirements for crucibles and other below-the-hook lifting devices. [06/26/2002]
- 1910.179 - Requirements for rated load tests for new or altered cranes. [08/28/2009]
- 1910.179 - Standards applicable to an automatic transfer device for processing and moving product. [01/16/2004]
- 1910.179 - Testing of hoist limit switches. [10/21/2003]
- 1910.179 - The design of trolley bumpers for electric overhead traveling cranes. [04/23/1979]
- 1910.179 - The need for an employer to comply with standards other than those which are enforced by OSHA. [02/27/1992]
- 1910.179 - Use of lower-limit device that stops lower hook travel with at least two wraps remaining on the drum. [04/25/2006]
- 1910.179 - Use of overhead bridge and gantry cranes as work platforms. [04/06/1993]
- 1910.179 - Whether crane lifting devices are considered to be part of the load and are allowed to be hoisted over personnel. [11/16/2007]
- 1910.179 - Wind Indicators and Rail Clamps. [03/08/1977]
- 1910.179(a)(2) - A worm drive gearbox is not considered to be a holding brake. [11/15/2005]
- 1910.179(a)(35) - Training for travel lift (mobile gantry crane) operators. [11/08/1999]
- 1910.179(b) - Guidelines for platforms and walkways on cranes. [06/25/1993]
- 1910.179(b) - Requirements for rated load tests for new or altered cranes. [08/28/2009]
- 1910.179(b)(2) - Clarification on physical qualifications for crane operators. [03/07/1983]
- 1910.179(b)(2) - Clarification on using an overhead crane beyond its rated load. [08/27/1975]
- 1910.179(b)(2) - Load testing of underhung trolleys/lifting devices. [11/02/1993]
- 1910.179(b)(4) - 1910.179(b)(4) only applies to outdoor storage bridge gantry cranes with spans over 100ft. [03/02/1976]
- 1910.179(b)(5) - Rated load markings for overhead bridge and gantry cranes. [02/25/1998]
- 1910.179(b)(6)(i) - Two-inch clearance must be maintained for overhead bridge cranes. [04/06/2001]
- 1910.179(b)(8) - Training for travel lift (mobile gantry crane) operators. [11/08/1999]
- 1910.179(d) - Guidelines for platforms and walkways on cranes. [06/25/1993]
- 1910.179(e)(2) - Applicability of bridge and trolley bumper requirements. [09/29/1975]
- 1910.179(e)(2) - Definition of slow rate of speed for crane bridges and trolleys. [10/23/1975]
- 1910.179(e)(3) - Applicability of bridge and trolley bumper requirements. [09/29/1975]
- 1910.179(e)(3) - Definition of slow rate of speed for crane bridges and trolleys. [10/23/1975]
- 1910.179(f)(1)(i) - A worm drive gearbox is not considered to be a holding brake. [11/15/2005]
- 1910.179(f)(1)(ii) - A worm drive gearbox is not considered to be a holding brake. [11/15/2005]
- 1910.179(h)(2)(i) - Clarification on OSHA requirements for hoist cables on cranes. [03/26/1976]
- 1910.179(h)(2)(iii)(a) - Definition of "extreme low position" for overhead and gantry cranes. [11/03/2005]
- 1910.179(h)(2)(iii)(a) - Use of lower-limit device that stops lower hook travel with at least two wraps remaining on the drum. [04/25/2006]
- 1910.179(i) - Clarification on whether a visual rotating beacon or strobe light is an acceptable warning signal on a radio operated crane. [03/30/2010]
- 1910.179(j)(1) - Clarification of Overhead and Gantry Cranes definition of "complete inspection" and "periodic inspection" requirements. [08/28/2003]
- 1910.179(j)(3) - Clarification of Overhead and Gantry Cranes definition of "complete inspection" and "periodic inspection" requirements. [08/28/2003]
- 1910.179(k) - Requirements for rated load tests for new or altered cranes. [08/28/2009]
- 1910.179(k)(1)(ii) - Testing of hoist limit switches. [10/21/2003]
- 1910.179(k)(2) - "Rated Load Test" for cranes as specified at 1910.179(k)(2). [01/03/1989]
- 1910.179(n)(2)(i) - Loads must be attached to the block hook by a sling or other approved device and may not be attached directly to the running rope. [10/06/2004]
- 1910.179(n)(2)(ii) - Loads must be attached to the block hook by a sling or other approved device and may not be attached directly to the running rope. [10/06/2004]
- 1910.179(n)(3)(vi) - An engine overhaul work station being developed. [03/08/1990]
- 1910.179(n)(3)(vi) - Operators of overhead and gantry cranes must not carry loads over people. [03/24/1999]
- 1910.179(n)(3)(vi) - Whether crane lifting devices are considered to be part of the load and are allowed to be hoisted over personnel. [11/16/2007]
- 1910.179(n)(3)(x) - Crane operator's responsibility during hand banding operations. [08/25/1975]
- 1910.179(n)(4) - Testing of hoist limit switches. [10/21/2003]