| 21. |
2006 - 07/20/2006 - Whether it is mandatory to use a wet saw when cutting brick or concrete block. |
17k |
OSHA requirements are set by statute, standards and regulations. Our interpretation letters explain these requirements and how they apply to particular circumstances, but they cannot create additiona...
http://www.osha.gov/pls/oshaweb/owadisp.show_document?p_table=INTERPRETATIONS&p_id=25456
|
| 22. |
2005 - 04/27/2005 - Requirements for maintaining Material Safety Data Sheets (MSDSs) for coal including coal dust, fly ash, and silica dust. |
16k |
April 27, 2005 John J. Frye, President Comprehensive Safety Compliance, Inc. 295 William Pitt Way Pittsburgh, PA 15238 Dear Mr. Frye: This is in response to your December 15, 2004, correspondence to ...
http://www.osha.gov/pls/oshaweb/owadisp.show_document?p_table=INTERPRETATIONS&p_id=25082
|
| 23. |
1989 - 02/08/1989 - Applicability of the HCS to crystalline silica, when bound in a polymeric compound and silicone rubber elastomers. |
12k |
February 8, 1989 Mr. D. A. Polsinelli Product Regulatory Specialist Product Regulatory Operation Silcone Products Division General Electric Company Waterford, New York 12188 Dear Mr. Polsinelli: This...
http://www.osha.gov/pls/oshaweb/owadisp.show_document?p_table=INTERPRETATIONS&p_id=19746
|
| 24. |
1999 - 05/12/1999 - Respirators for silica dust must be selected based on exposure levels. |
12k |
May 12, 1999 Mr. David Koch Senior Technical Service Specialist DALLOZ SAFETY P.O. Box 622 Reading, PA 19603-0622 Dear. Mr. Koch: This letter is in response to your March 24, request for clarificatio...
http://www.osha.gov/pls/oshaweb/owadisp.show_document?p_table=INTERPRETATIONS&p_id=22737
|
| 25. |
1991 - 09/25/1991 - Labeling Requirements for Crystalline Silica Products. |
14k |
September 25, 1991 William B. Bunn, III, M.D., J.D., M.P.H. Senior Director Health, Safety & Environment Manville Sales Corporation Post Office Box 5108 Denver, Colorado 80217-5108 Dear Dr. Bunn: Tha...
http://www.osha.gov/pls/oshaweb/owadisp.show_document?p_table=INTERPRETATIONS&p_id=20406
|
| 26. |
1996 - 08/20/1996 - Railroad workers and their exposure to crystalline silica. |
15k |
August 20, 1996 Mr. Richard N. Shapiro Wilson, Hajek & Shapiro, P.C. Attorneys At Law 1294 Diamond Springs Road Post Office Box 5369 Virginia Beach, Virginia 23455 Dear Mr. Shapiro: Thank you for you...
http://www.osha.gov/pls/oshaweb/owadisp.show_document?p_table=INTERPRETATIONS&p_id=22238
|
| 27. |
2007 - 03/22/2007 - Explanation of OSHA's determination of the PEL for amorphous silica. |
14k |
March 22, 2007 Mr. Mark J. Pereira, CIH Practical Safety Solutions, LLC PO Box 792 50 Browns Lane Old Lyme, CT 06371 Dear Mr. Pereira: Thank you for your September 7, 2006 letter to the Occupational ...
http://www.osha.gov/pls/oshaweb/owadisp.show_document?p_table=INTERPRETATIONS&p_id=25740
|
| 28. |
2004 - 02/11/2004 - Application of the hazard communication standard to latex paints containing less than 6% crystalline silica. |
17k |
February 11, 2004 Ms. Allison Keane, Esq. Counsel, Government Affairs National Paint and Coatings Association 1500 Rhode Island Avenue, N.W. Washington, D.C. 20005 Dear Ms. Keane: Thank you for your ...
http://www.osha.gov/pls/oshaweb/owadisp.show_document?p_table=INTERPRETATIONS&p_id=24783
|
| 29. |
1988 - 09/20/1988 - Crystalline silica considered a carcinogen under the HCS. |
20k |
September 20, 1988 Mr. Theodore L. Garrett Covington and Burling Post Office Box 7566 Washington, D.C. 20044 Dear Mr. Garrett: This is in further response to your letter of May 23 which petitioned th...
http://www.osha.gov/pls/oshaweb/owadisp.show_document?p_table=INTERPRETATIONS&p_id=19704
|
| 30. |
1986 - 02/11/1986 - Use of silica as an abrasive blaster. |
15k |
February 11, 1986 The Honorable Gary Hart United States Senator 1748 High Street Denver, Colorado 80218 Dear Senator Hart: Your letter of January 9, to former Assistant Secretary Robert Rowland conce...
http://www.osha.gov/pls/oshaweb/owadisp.show_document?p_table=INTERPRETATIONS&p_id=19380
|