Standard Interpretations - Table of Contents Standard Interpretations - Table of Contents
• Standard Number: 1910.157

May 26, 1995

Mr. Frank Schreiber
Kulback's Construction Inc.
6363 Transit Road
Depew, New York 14043

Dear Schreiber:

This is in response to your letter of March 7 regarding the size of fire extinguisher for construction equipment.

Per our conversation of May 23, the Occupational Safety and Health Administration's (OSHA) fire protection and prevention standard (29 CFR 1926.150 - Subpart F) does not state any specific weight or size requirements for fire extinguishers on construction equipment. As part of a fire prevention plan, a hazard assessment should be performed in order to determine potential hazards that exist and the types of fire fighting equipment that would be necessary.

We appreciate your interest in employee safety and health. If you require further assistance, please contact Dale Cavanaugh in the Office of Construction and Maritime Compliance Assistance on 202-219-8136.

Sincerely,



Raymond E. Donnelly, Director
Office of General Industry Compliance

Enclosures



US Department of Labor
OSHA
200 Constitution Avenue - NW
Washington D.C. 20210

ATTN: Construction Standards

RE: Fire Extinguisher Regulations

To who it may concern:

Could you please send me information regarding what size fire extinguisher's are required for construction equipment. As per your manual, no size was noted. Please send this information to the following address:

Kulback's Construction Inc. 6363 Transit Road Depew, New York 14043

Attention: Mr. Frank Schreiber

Thank you.

Sincerely,



Frank Schreiber
Site Supervisor

Standard Interpretations - Table of Contents Standard Interpretations - Table of Contents